Instruction manual
6
Set the duration of the scan time
You can set the duration of the scan time to 3, 8, 15, or 30 seconds.
To change the scan time, do one of the following:
• Press port selection buttons 1 and 2 simultaneously. The KVM switch beeps to
indicate the duration of the scan time. It will beep once for 3 seconds, twice
for 8 seconds, three times for 15 seconds, and four times for 30 seconds.
• If you’re using a computer that’s running a version of Windows or Linux, you
can use hotkey commands to start an Auto Scan. To use the hotkey command,
press Left Ctrl, Left Ctrl, F3. The KVM switch beeps to indicate the duration of
the scan time. It will beep once for 3 seconds, twice for 8 seconds, three times
for 15 seconds, and four times for 30 seconds. For more information about
hotkey commands, see the “Using hotkey commands” section of the manual.
Using hotkey commands
If you’re using a computer that’s running a version of Windows or Linux, you can use
hotkey commands to operate the KVM switch. All hotkey commands begin by pressing
the Left Ctrl key twice and then pressing one or two additional keys.
The KVM switch emits a high-pitched beep when you enter a correct hotkey command
sequence and low-pitched beep when you enter an incorrect command. Incorrect
hotkey commands aren’t sent to the computer.
Note: Hotkey commands aren’t supported in the macOS operating system.
Disable hotkey commands
By default, hotkey commands are enabled on the KVM switch.
• To disable hotkey commands, press and hold the Left Shift key and press Num
Lock twice. Release the Left Shift key and then press the Left Ctrl key.
To enable hotkey commands, repeat the key sequence used to disable the hotkey
commands.
To Next Page
Loading...
Need help?
General
