Troubleshooting
UR22 Operation Manual 14
8) of the Yamaha Steinberg USB Driver control
panel.
Unusual Sound (noise,
interruption, or distortion)
・Is the buffer size set too low?
Increase the buffer size compared to the current
settings; refer to the section “Yamaha Steinberg
USB Driver”(page 8) for instructions.
・Does your computer satisfy the
system requirements?
Confirm the system requirements. For the latest
information, see the Steinberg web site below.
http://www.steinberg.net/
・Are you recording or playing long
continuous sections of audio?
The audio data processing capabilities of your
computer will depend on a number of factors
including CPU speed and access to external
devices. Reduce the audio tracks then confirm the
sound.
・Is a network adaptor for wired/
wireless LAN running?
Disable the suspected network adaptor. Some
network adaptors can cause noise.
Double Sound
・Both the input signal to the
device and the output signal from
DAW software are being output.
Turn the [MIX] knob fully to the [DAW] side.
Computer does not recognize
the device.
(USB indicator does not
switch from flashing to being
continuously lit.)
・Has Yamaha Steinberg USB
Driver been installed properly?
Refer to the Getting started to complete Yamaha
Steinberg USB Driver installation.
To Next Page
Loading...
