EasyManua.ls Logo

Steinsvik Orbit-3500 - User Manual

Default Icon
46 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Steinsvik AS Rundhaug 25, 5563 Førresfjorden, Norway | +47 52 75 47 00 | post@steinsvik.no | www.steinsvik.no
User manual
Camera System

Table of Contents

Questions and Answers

  • M
    maynardangelicaAug 6, 2025
    What to do if Steinsvik Digital Camera winch will not work?
    • L
      Laura HancockAug 7, 2025
      If the Steinsvik Digital Camera winch won't work, several factors could be at play. First, check for any growth on the rope and remove it. Next, ensure the winch rope isn't jammed; if it is, try loosening any knots. Inspect the winch cable for breaks or damages, paying attention to the contacts on the cable and in the PSU. Also, confirm that the camera rope is correctly threaded inside the circlip. Finally, a broken fuse could be the culprit, so check the fuse inside the PSU and replace it if necessary, but remember that only authorized personnel should perform this task.
  • P
    Pamela CharlesAug 22, 2025
    Why does Steinsvik Orbit-3500 winch jerk or stop before reaching the bottom?
    • T
      thamptonAug 22, 2025
      If the Steinsvik Digital Camera winch jerks or stops before reaching the bottom, it could be due to a misplaced bottom stop switch. To resolve this, raise the hoop stopper up and down to the stop screw. A 'click' from the switch inside the winch should occur approximately 5 mm from the bottom position. If the hoop must be raised 1 cm or more to hear the click, the bottom stop switch is misplaced. Another potential cause is an error in the motor protection on the circuit board, in which case Steinsvik recommends a service on the winch.

Summary

Safety

Assessment of escape risk

Technical description

Surface camera

Describes the Orbit-200B and Orbit-210 surface cameras and their specifications.

PSU

Multiwinch

Orbit-bracket for ring

Orbit-bracket for ring with clamp

Preparation and installation

Orbit Bracket for ring

Mast;Alu pipe

PSU;Protection cabinet

Winch and winch rope

Rope and strain relief

Surface camera

Operating instructions

Multiwinch;underwater camera

How to operate the winch and camera system using software or physical buttons.

Surveillance camera

Maintenance

Routine inspection and periodic maintenance

Table outlining components, descriptions, and intervals for routine maintenance.

Larger reparations and modifications

Troubleshooting and correction of errors

Provides a troubleshooting table for common problems and their solutions.

Storing, preservation and maintenance

Spare parts

Underwater camera

Lists spare parts and product numbers for various Orbit-3000 series underwater cameras.

Obritt-200 (411340) and Orbit-210 (430755)

Lists spare parts, product numbers, and quantities for Orbit-200 and Orbit-210 cameras.

Multiwinch (100069)

Lists spare parts and product numbers for the Multiwinch.

Orbit-Bracket for ring (405461)

Lists spare parts and product numbers for the Orbit-Bracket for ring.

Orbit-bracket for ring with clamp (V-Clamp) (442778)

Lists spare parts and product numbers for the Orbit-bracket with clamp.

Antenna (411859)

Strain Relief (420438)

Orbit-310 (410478)

Lists spare parts and product numbers for the Orbit-310 camera.

Steinsvik Orbit-3500 Specifications

General IconGeneral
Effective Pixels5.0 Megapixels
Optical Zoom3x
Digital Zoom4x
Storage MediaSD/MMC card
Image Sensor1/2.5" CCD

Related product manuals