− Connect everything else before connecting to 230 V.
− Disconnect power supply before disassembly.
− Inspect for any damage on the metal hoop on the camera before submerging the
camera
− When the camera contact is disconnected from the rest: remove all sand and growth
with isopropyl alcohol and apply Molykote before reassembly.
− Tie the camera rope from the Multiwinch to the hoop on the underwater camera.
− Apply a thin layer Molykote 44 (approx. 1/10 of the depth of the contact, approx. 1 mm).
− Attach the camera cable to the camera.
− Ensure that the camera is hanging correctly; the rope should keep the plug in the right
position.
Figure 18 Camera contact, metal hoop on
camera and camera rope
To Next Page
Loading...
