Steinsvik Orbit-3500 - Storing, preservation and maintenance

37
prevent the engine from tearing
the ropes or burning out.
Steinsvik recommend a service
on the winch if it fails to lift the
camera in the water.
Picture come and go
Broken camera cable
Replace camera cable or try with
a cable from a different cage.
«No video» on pc-screen
Camera is not connected to
the PSU
Ensure the camera is properly
connected
«No video» on pc-screen
Defective camera fuse
Use «camera tools» in the
software to check status on the
fuse. If the fuse is broken, verify
what caused this before
changing the fuse.
7.4 Link to troubleshooting for camera system
https://help.steinsvik.no
7.5 Storing, preservation and maintenance
Disconnect power supply before disassembly
Steinsvik AS recommend storing the equipment indoors. This includes the Orbit-bracket
for ring and ropes.
1. Clean the ropes for any growth and rinse with clean water. Check for any damages resulting
from wear and tear and order new ropes if necessary.
2. Rinse aluminium parts with clean water. To avoid oxidation, cover all contact surfaces/screw
threads with grease.
3. Rinse, clean and wipe dry all cables to remove any salt residues. Check for wear and tear,
change if necessary. Coil the cables together for storage.
4. Clean the camera to remove all growth. Steinsvik AS recommend sending the camera for
service after every generation (change gaskets, calibration of sensors).
5. Clean the winch and PSU for salt and check all contacts; Evaluate whether to submit for service
to prepare it for a new generation. Store indoors to prevent moisture from entering contacts and
lid when not in the intended position (contacts down).
6. Fibre cable: If the plug of the fibre cable has come into contact with saltwater during
disconnection, rinse it immediately in clean water. Allow to dry completely before reinstalling the
lid. When coiling the cable make sure that the cable is not heavily bent; min. bending radius is
50 cm to avoid damage to fibres.