- Enable ICMP-FLOOD Attack Filtering - Enable or Disable the
ICMP-FLOOD Attack Filtering.
- ICMP-FLOOD Packets threshold: (5 ~ 3600) - The default value
is 50. Enter a value between 5 ~ 3600 packets. When the current
ICMP-FLOOD Packets numbers is beyond the set value, the
router will start up the blocking function immediately.
- Enable UDP-FLOOD Filtering - Enable or Disable the
UDP-FLOOD Filtering.
- UDP-FLOOD Packets threshold: (5 ~ 3600) - The default value
is 50. Enter a value between 5 ~ 3600 packets. When the
current UPD-FLOOD Packets numbers is beyond the set value,
the router will start up the blocking function immediately.
- Enable TCP-SYN-FLOOD Attack Filtering - Enable or Disable
the TCP-SYNFLOOD Attack Filtering.
- TCP-SYN-FLOOD Packets threshold: (5 ~ 3600) - The default
value is 50. Enter a value between 5 ~ 3600 packets. When the
current TCP-SYN-FLOOD Packets numbers is beyond the set
value, the router will start up the blocking function immediately.
- Ignore Ping Packet from WAN Port - Enable or Disable ignore
ping packet from WAN port. The default is disabled. If enabled,
the ping packet from the Internet cannot access the router.
- Forbid Ping Packet from LAN Port - Enable or Disable
forbidding Ping Packet to access the router from the LAN port.
The default value is disabled. If enabled, the ping packet from
the LAN port cannot access the router. (Defends against some
viruses)
Click the Save button to save the settings.
Click the Blocked DoS Host Table button to display the DoS host
table by blocking. The page will appear that shown in fi gure 53:
ENGLISH
ENGLISH-60
To Next Page
Loading...
Need help?
General
