4-2
P093932-203 Equipment Manual Cleaning the Equipment
4.2 General
Cleaning/Disinfecting
Procedure
1. Ensure system power is turned off and lighthead has cooled
sufficiently.
2. Wear rubber gloves.
3. Prepare an approved cleaning or disinfecting solution in
accordance with the directions on the container’s label.
Important: DO NOT use aggressive products such as floor
cleaners, paint thinners, alkaline detergents or acids.
Important: The use of aggressive products such as floor
cleaners can cause the plastic parts to crack and can damage
the painted metal surfaces of the Harmony
®
LED385
Examination Lighting System.
4. DO NOT SPRAY anything directly onto the lighthead or system
components. Dampen a soft cloth with the cleaning solution and
wring out the excess moisture.
5. Thoroughly wipe the areas to be cleaned (see Figure 4-1).
6. Rinse all surfaces with a clean, soft cloth wipe and clear water.
7. Wipe all surfaces dry with a clean, dry soft cloth.
8. Verify sterilizable handle (when used) is sterilized using a
standard hospital cycle.
WARNING – ELECTRIC
SHOCK HAZARD: Verify that
power to examination lighting
system is off before cleaning.
WARNING – PERSONAL
INJURY AND/OR EQUIPMENT
DAMAGE HAZARD: Do not
attempt to clean the lighthead
unless lighthead has cooled
sufficiently.
CAUTION – POSSIBLE
EQUIPMENT DAMAGE:
• Always follow manufacturer
instructions for
concentrations and use of
cleaning products.
• Prevent leakage of fluids
into interior of lighthead,
control keypad and support
arm system.
• Do not use abrasive
products, gasoline, paint
thinners, alkaline
detergents or acids.
• DO NOT SPRAY any
cleaning product directly
onto the lighthead or any
system components. Clean
by dampening a soft cloth
with the cleaning solution
and wring out the excess
moisture.
To Next Page
Loading...