Maintenance Operator Manual T6800 Rev B
SYSTEM 1 endo Liquid Chemical Sterilant Processing System
9-23
Part 7:
Control Value
Programming
SYSTEM 1 endo
Processor is shipped with factory-set cycles, cycle values, and
control values programmed into the control. These are the values to which the
control will default should a battery or battery-powered memory failure ever occur.
Some preset values can be changed to customize the SYSTEM 1 endo Processor
to the operating environment in which it has been placed. To change any of these
values, refer to the Change Values procedure later in this section.
NOTE: If a battery/memory failure should occur, operator-set values would
be lost. The factory-set control values would then appear on the
display when the power is restored and the unit switched on.
Change Machine Setup
Setup options are used to change the way the SYSTEM 1 endo Processor
operates in a general way. When an Access Code is set, all selections will
“lock out” except Language, (see “Access Code,” later in this section, for more
information on this feature). All setup options are accessed from the CHANGE
VALUES touch pad.
Setup options that can be adjusted are summarized below. These options appear
on the display in the same order as listed below. Each option is detailed in the
pages that follow.
NOTE: Cycle values (time, temperature) cannot be adjusted.
To Next Page
Loading...
Need help?
General
