www.stiebel-eltron.com LWZ130 | 29
ENGLISH
CoNTeNTs
SPECIAL INFORMATION
OPERATION
1. General information ���������������������������������������� 30
1.1 Safety instructions ����������������������������������������������� 30
1.2 Other symbols in this documentation �����������������������30
1.3 Information on the appliance ���������������������������������31
1.4 Standardised output data ��������������������������������������31
1.5 Units of measurement ������������������������������������������31
2. Safety ��������������������������������������������������������� 31
2.1 Intended use ������������������������������������������������������ 31
2.2 General safety instructions ������������������������������������31
2.3 Test symbols ������������������������������������������������������31
3. Appliance description �������������������������������������� 31
3.1 Frost protection ��������������������������������������������������32
3.2 Passive cooling ��������������������������������������������������� 32
3.3 LWZ 130 Enthalpie : Enthalpy heat exchanger �������������� 32
4. Settings ������������������������������������������������������ 32
4.1 Switching the appliance on ������������������������������������32
4.2 Programming unit �����������������������������������������������32
4.3 Selecting the fan stage �����������������������������������������33
4.4 Activating time programs ��������������������������������������33
4.5 Menu ���������������������������������������������������������������33
P1 : Set room temperature �������������������������������������33
P3 : Passive cooling operating mode �������������������������34
P4 : Reset filter ����������������������������������������������������34
P28 : Enable fan ���������������������������������������������������34
P80 : Day �����������������������������������������������������������34
P83 : Mode of backlighting �������������������������������������34
P84 : Illumination duration �������������������������������������34
P85 : Lower standard display ����������������������������������34
Pro ������������������������������������������������������������������35
Cod ������������������������������������������������������������������35
4.6 Switching off the appliance ������������������������������������35
5. Maintenance, cleaning and care ��������������������������� 36
5.1 Replacement filters ���������������������������������������������� 36
5.2 Filter inspection and replacement ���������������������������36
6. Troubleshooting ��������������������������������������������� 37
INSTALLATION
7. Safety ��������������������������������������������������������� 37
7.1 General safety instructions ������������������������������������37
7.2 Instructions, standards and regulations ��������������������37
7.3 Operation of the appliance in buildings with
combustion equipment ����������������������������������������� 37
8. Appliance description �������������������������������������� 38
8.1 Standard delivery ������������������������������������������������38
8.2 Accessories ��������������������������������������������������������38
9. Preparation �������������������������������������������������� 38
9.1 Storage �������������������������������������������������������������38
9.2 Installation site ��������������������������������������������������� 38
9.3 Transport ����������������������������������������������������������39
10. Installation ��������������������������������������������������� 39
10.1 Mounting the appliance ����������������������������������������39
10.2 Connecting the condensate drain hose ����������������������40
10.3 Air ducts ����������������������������������������������������������� 41
10.4 Electrical connection ������������������������������������������� 42
10.5 Overflow apertures ��������������������������������������������� 43
11. Commissioning ��������������������������������������������� 43
11.1 Initial start-up ��������������������������������������������������� 43
11.2 Recommissioning ����������������������������������������������� 43
12. Settings ����������������������������������������������������� 44
12.1 Parameter ��������������������������������������������������������44
P14 : Supply air flow rate offset ������������������������������44
P15 : Humidity protection interval ��������������������������� 45
P16 : Start-up time for humidity measurement ����������� 45
P22 : Enable preheater ����������������������������������������� 45
P24 : Passive cooling release temperature ����������������� 45
P25 : Passive cooling blocking temperature ��������������� 45
P26 : Passive cooling hysteresis ������������������������������ 45
P27 : Temperature differential for enabling passive
cooling ������������������������������������������������������������ 45
P29 : Appliance type �������������������������������������������� 45
P30 : Temperature for enabling frost protection ���������� 45
P31 : Enabling of humidity-dependent flow rate control 45
P70 : Delete fault list �������������������������������������������� 45
12.2 Actual values ���������������������������������������������������� 45
12.3 Code ��������������������������������������������������������������� 45
Cod ����������������������������������������������������������������� 45
13. Appliance shutdown ��������������������������������������� 46
14. Maintenance ������������������������������������������������ 46
15. Troubleshooting �������������������������������������������� 47
16. Disposal ����������������������������������������������������� 47
17. Specification ������������������������������������������������ 48
17.1 Dimensions and connections ��������������������������������� 48
17.2 Fan diagram ����������������������������������������������������� 49
17.3 Wiring diagram ������������������������������������������������� 50
17.4 Data table �������������������������������������������������������� 51
GUARANTEE
ENVIRONMENT AND RECYCLING
FILTER INSPECTION LOG
326794-41212-9444_LWZ_130_de_en.indb 29 09.05.2019 12:05:49