STIEBEL ELTRON WPF 04

40 |WPF | WPF cool www.stiebel-eltron.com
INSTALLATION
Settings
14. Settings
14.1 Standard settings
At the factory, the heat pump manager is programmed with the
following standard settings:
Switching times for heating circuit1 and2 (day mode)
only the 1stswitching pair is pre-programmed.
Standard Setting range
Monday - Friday 6:00 - 22:00 0:00 - 23:59
Saturday - Sunday 7:00 - 23:00 0:00 - 23:59
Room temp. 1 / 2
Standard settings without night setback.
Room temperature in day mode 20°C 5 - 30°C
Room temperature in night mode 20°C 5 - 30°C
DHW program switching times
Monday - Sunday 0:00 - 24:00 0:00 - 23:59
DHW temperature
DHW day temperature 50 °C OFF / 50 - 70 °C
DHW night temperature 50 °C OFF / 50 - 70 °C
Heating curve slope
Heating curve 1 0.6 0 - 5
Heating curve 2 0.2 0 - 5
14.2 Heating and DHW programs
You may enter your individual programs into the following tables.
14.2.1 Heating program, heating circuit 1
Switching time
pair I
Switching time
pair II
Switching time
pair III
Mon
Tue
Wed
Thu
Fri
Sat
Sun
Mo - Fr
Sa - Su
Mo-Su
14.2.2 Heating program, heating circuit 2
Switching time
pair I
Switching time
pair II
Switching time
pair III
Mon
Tue
Wed
Thu
Fri
Sat
Sun
Mo - Fr
Sa - Su
Mo-Su
14.2.3 DHW program
Switching time
pair I
Switching time
pair II
Switching time
pair III
Mon
Tue
Wed
Thu
Fri
Sat
Sun
Mo - Fr
Sa - Su
Mo-Su
14.3 Appliance handover
Explain the appliance function to users and familiarise them with
its operation.
Note
Hand over these operating and installation instructions
to the user for safe-keeping. Always carefully observe all
information in these instructions. They provide informa-
tion on safety, operation, installation and maintenance
of the appliance.