Stihl 019 T User Manual

STIHL 019 T
33
6.5 Starter Grip (ElastoStart)
The starter grip is supplied complete
with starter rope.
- Remove the fan housing - see 6.2.
- Remove the rope rotor - see
"General Servicing, Trouble-
shooting" handbook.
• Pull rope back until the knot locates
in the starter grip.
- Press cap into the starter grip.
- Fit the starter rope on the rotor, see
"General Servicing, Trouble-
shooting" handbook.
• Thread rope through the side of the
rotor.
- Push it through the inner bore from
the underside, pull it out at the top
and secure with a simple overhand
knot.
- Grip knot and pull it out of rope
rotor.
• Undo the knot and remove the
starter rope from the rotor and fan
housing.
• Pull the rope back into the rotor
so that the knot locates in the
recess.
- Install the rope rotor - see
"General Servicing, Trouble-
shooting" handbook.
- Tension the rewind spring
- see 6.3.2.
- Refit the fan housing - see 6.2.
• Thread the new starter rope
through the guide bush from
outside.

Stihl 019 T Specifications

General

Brand	Stihl
Model	019 T
Category	Chainsaw
Language	English