STIHL 019 T
29
5.5 Contact Spring
• Pull out the ground and short
circuit wires.
Install in the reverse sequence.
- Remove the fan housing - see 6.2.
• Pull ground wire off the contact
spring.
- Wiring harness must not locate
against engine housing's filter
wall; pull wiring harness back in
direction of ignition module.
- Position protective tube with
ground and short circuit wires
correctly in rear retainers of
handle.
• Make sure ground wire is properly
positioned in front of handle.
• Pull the contact spring off the lug.
Install in the reverse sequence.
To Next Page
Loading...
