Stihl 019 T User Manual

STIHL 019 T
28
• Pull the short circuit wire out of
switch shaft.
• Open the grommet.
• Take the throttle cable out of the
retainer.
• Take out the upper screw (1).
• Disconnect the short circuit wire (2).
5.4 Ground Wire/Short Circuit Wire
• Take the protective tube with the
ground and short circuit wires out of
the retainers in the handle.
- Remove throttle trigger - see 8.1.
• Pull ground wire off the contact spring.
Inspect the condition of the flywheel (1)
and magnets (2). If you find any
damage (e.g. cracks, broken fan
blades), fit a new flywheel.
Installing the flywheel:
Important: Clean the stub of the
crankshaft and the flywheel hub bore
with a standard commercial, solvent-
based degreasant containing no
chlorinated or halogenated
hydrocarbons - see 11.2.
- Fit the flywheel.
- Fit flywheel nut and tighten down to
28 Nm (21 Ibf.ft).
- Take out the locking strip.
- Fit the spark plug and tighten
down to 25 Nm (18.5 Ibf.ft).
- Fit the fan housing - see 6.2.

Stihl 019 T Specifications

General

Brand	Stihl
Model	019 T
Category	Chainsaw
Language	English