Stihl 019 T - Page 38

STIHL 019 T
38
• Push the rubber buffer out of the top
handle.
• Press the top handle against the
rubber buffer.
• Pry the rubber buffer into the top
handle.
• Make sure ground wire, short circuit
wire and throttle cable are correctly
positioned in the top handle.
• Inspect rubber plug and replace if
necessary.
Install in the reverse sequence.
• Rotate plug (with key) approx. 90
degrees and take it out of the
annular buffer.
• Position the plug so that the front
key (1) lines up with the slot in the
inner plug.
• Push the plug in until you feel
noticeable resistance.
• Now turn plug about 90 degrees
(the rear key (2) then lines up with
the slot) and push it home until it
butts against the rubber buffer.
- Rotate the plug another 90
degrees.
• Remove the top handle and pull out
the throttle cable (1) and protective
tube (2) with ground and short
circuit wires at the same time.
• Pry plug (with key) out of annular
buffers.