How to reduce vibration on a Stihl MH 700?
Excessive vibration during operation of your Stihl Tiller can be caused by several issues. A loose engine mounting can cause vibration, so tighten the engine mounting bolts. Incorrectly installed hoes can also lead to vibration, so install the hoes correctly. Worn hoes can also cause vibration, so replace them. An incorrectly set blade spur can also be a factor, so adjust the blade spur.
Why is my Stihl Tiller gearbox so loud?
If you are experiencing loud gearbox noise with your Stihl Tiller, check the oil level in the gearbox.
Why won't my Stihl MH 700 Tiller engine start?
There could be several reasons why your Stihl Tiller engine won't start. One possibility is that the fuel tank is empty, in which case you should refuel the tiller. Another reason could be that the main switch is set to the 0 position; if so, press the main switch. It might also be due to using inferior, dirty, or old fuel. Try using fresh, good quality unleaded petrol and cleaning the carburetor and fuel line. A detached spark plug socket or a loose ignition lead can also prevent starting, so ensure these are properly connected. Lastly, a dirty, damaged spark plug or an incorrect electrode gap could be the culprit; clean or replace the spark plug and adjust the electrode gap if needed.
How to improve the tilling performance of my Stihl MH 700 Tiller?
If the tilling performance of your Stihl Tiller is reduced, make sure the hoes are installed correctly. Replace the hoes if they are worn. Also, ensure that the blade spur is correctly set. For a worn drive belt, it is recommended to consult a STIHL specialist dealer.
What to do if my Stihl MH 700 Tiller has an oil bath air filter dirty?
If the oil bath air filter in your Stihl Tiller is dirty, clean or replace it.
What to do if my Stihl Tiller spark plug is dirty?
If the spark plug in your Stihl Tiller is dirty, clean or replace it.
Why is my Stihl MH 700 engine overheating?
If your Stihl Tiller engine is overheating, several factors could be the cause: * Dirty cooling ribs: Clean the cooling ribs. * Low oil level: Top up the engine oil. * Earth on the engine surface: Remove the earth. * High engine speed: Reduce the speed.
What to do if my Stihl MH 700 Tiller engine is running roughly?
If your Stihl Tiller engine is running roughly, several factors could be the cause. A dirty oil bath air filter can lead to rough running, so clean or replace it. Using the incorrect fuel can also cause this issue, so check the fuel. Insufficient fuel in the fuel tank can also be a factor, so refill the fuel tank.
How to fix heavy smoke from Stihl Tiller?
If your Stihl Tiller is producing heavy smoke, it could be due to several reasons. The oil level in the engine might be too high, so drain some engine oil. A dirty oil bath air filter can also cause this issue, so clean or replace it. Lastly, if the machine's angle of inclination is over 15°, place the machine in a horizontal working position.
What to do if my Stihl MH 700 Tiller engine is hard to start?
If your Stihl Tiller engine is difficult to start or the engine power is deteriorating, it could be due to several reasons. Water in the fuel tank and carburetor, or a blocked carburetor, can cause this issue, so empty the fuel tank, and clean the fuel line and carburetor. A contaminated fuel tank can also be the reason, so clean the fuel tank. Additionally, a dirty oil bath air filter can cause starting problems, so clean or replace the oil bath air filter. A dirty spark plug may also be the reason, so clean or replace the spark plug. Finally, check the fuel, as using the incorrect fuel can also cause these issues.
Covers warning symbols, intended use, and user requirements for safe operation.
Explains safe tiller condition checks and rotor blade safety.
Provides critical safety instructions for handling and refueling the tiller with petrol.
Guidance and warnings for operating, transporting, and storing the tiller safely.
Outlines safety precautions for all cleaning, maintenance, and repair tasks.
Details on how to properly top up gearbox and engine oil.
Provides step-by-step instructions for safe refueling of the tiller.
Step-by-step instructions for starting and stopping the tiller's engine.
Details how to engage and disengage the tiller's self-propulsion system.
Outlines recommended maintenance schedules and gearbox lubrication.
Details on checking and changing the gearbox oil level.
A comprehensive guide to diagnosing and fixing common tiller problems.
Covers essential preparatory steps and safety during maintenance/storage.
To Next Page
General
