Stihl RMI 522 C - Page 79

EN
77
0478 131 8365 C - EN
Message:
1000 – Rollover
Allowed inclination exceeded
Possible cause:
– Tilt sensor has detected a rollover
Remedy:
– Place robotic mower on its wheels,
check for damage and confirm
message with OK
Message:
1010 – iMOW® raised
Press OK to release
Possible cause:
– Robotic mower has been lifted by hood
Remedy:
– Check movement of hood and confirm
message with OK
Message:
1030 – Hood fault
Check hood
Then press OK
Possible cause:
– No hood detected
Remedy:
– Check hood (movement, firm seating)
and confirm the message with OK
Message:
1105 – Flap open
Operation aborted
Possible cause:
– Flap open during automatic operation
– Flap open during automatic edge
following
Remedy:
– Close the flap (Ö 15.2)
Message:
1120 – Hood blocked
Check hood
then press OK
Possible cause:
– Permanent collision detected
– Uneven areas around or underneath
docking station floor plate
Remedy:
– Free robotic mower, remove obstacle or
change routing of perimeter wire if
necessary – then confirm message with
OK
– Check movement of hood and confirm
message with OK
– Level out uneven areas and confirm
message with OK (Ö 9.1)
Message:
1125 – Remove obstacle
Check wire routing
Possible cause:
– Perimeter wire routed inaccurately
Remedy:
– Check routing of the perimeter wire,
check clearances using the
iMOW® Ruler (Ö 12.5)
Message:
1126 – Cancel teach-in
Teach-in failed
Remove obstacle
Possible cause:
– Obstacle in the area of the perimeter
wire
– Hood has been lifted
– Wire routing incorrect
Remedy:
– Free robotic mower, remove obstacle or
change routing of perimeter wire if
necessary
– Check movement of the hood
– Level out uneven areas
– Confirm the message with OK
– Restart teach-in run if necessary
Message:
1127 – Cancel teach-in
Teach-in failed
Possible cause:
– STOP button was pressed
– Allowed inclination exceeded
– Delete/save internal map of the mowing
area failed
– Docking was not successful
Remedy:
– Confirm the message with OK
– Restart teach-in run if necessary
Message:
1128 – Direct drive home
Drive home on the wire aborted
Possible cause:
– Direct drive home could not be
successfully completed
Remedy:
– No action required, confirm message
with OK if necessary
– Contact your STIHL specialist dealer if
the problem persists