0478 192 9809 A - EN
46
The fuel cock (1) is opened and closed by
turning the control valve (2).
15.8 Checking the engine oil filling
level
● Park the machine on a flat, level
surface.
● Stop the engine. (Ö 13.3)
● Engage the parking brake. (Ö 8.14)
● Allow the engine to cool down.
● Open the engine hood. (Ö 15.3)
● Check the filling level as per the engine
instruction manual – top up the engine
oil if necessary. (Ö 15.10)
15.9 Changing the engine oil
Information regarding the specified engine
oil and oil capacity can be found in the
engine instruction manual.
Perform an oil change when the engine is
warm to the touch. Place a suitable oil
collection container (note engine oil
capacity) under the oil drain tube.
Dispose of used oil in conformance with
statutory requirements.
Oil change interval:
The recommended oil change intervals
can be found in the engine instruction
manual.
Draining the engine oil:
● Stop the engine. (Ö 13.3)
● Engage the parking brake. (Ö 8.14)
● Remove the ignition key and keep it in a
safe place.
● Allow the engine to cool down (warm to
the touch).
● Open the engine hood. (Ö 15.3)
● Unscrew the oil cap (see engine
instruction manual).
The oil drain tube (1) is located on the
right-hand side of the engine, near the two
pedals.
● Place a suitable oil collecting container
underneath.
Using two spanners (A/F 19/A/F 15),
unscrew the oil drain plug (1) and remove.
Dispose of the seal ring (2).
● Drain all the engine oil.
Then fit the new seal ring (2) onto the oil
drain plug (1). Screw the oil drain plug
into the oil drain tube and tighten to
12 - 14 Nm.
Risk of injury!
Allow the engine to cool down
before topping up the engine oil or
before changing the oil.
Danger of burns due to hot engine
oil.
To Next Page
Loading...
