0458-828-9621-B
43
English
13 Changing the Blower for Use as a Vacuum Shredder
12.5 Blowing
► Insert the battery and switch the blower on.
► Point the nozzle at the ground.
► Move forward slowly in a controlled manner.
13.1 Changing the Blower for Use as a Vacuum
Shredder
► Switch off the blower and remove the battery.
► Remove the blower tube.
► Turn the control handle.
► Attach the suction tube.
► Attach the catcher bag.
14.1 When Work is Finished
► Switch off the vacuum shredder and remove the battery.
► Empty the catcher bag.
► If the vacuum shredder is wet: Leave the vacuum
shredder to dry.
► If the catcher bag is wet: Leave the catcher bag to dry.
► If the battery is wet: Leave the battery to dry.
► Clean the vacuum shredder.
► Clean the catcher bag.
► Clean the battery.
15.1 Transporting the Vacuum Shredder
► Switch off the vacuum shredder and remove the battery.
► If the suction tube is removed: Close the shield.
Carrying the vacuum shredder
► Carry the vacuum shredder with one hand by the loop
handle with the suction tube behind you.
► If the vacuum shredder is changed for use as a blower:
Carry the blower with one hand by the control handle.
Transporting the vacuum shredder in the car
► Secure the vacuum shredder so that it cannot turn over or
move.
15.2 Transporting the battery
► Switch off the vacuum shredder and remove the battery.
► Check that the battery is in a safe condition.
► Pack the battery so that the following points apply:
– The packaging is electrically non-conductive.
– The battery cannot move inside the packaging.
► Secure the packaging so that it cannot move.
The battery is subject to the Carriage of Dangerous Goods
regulations. The battery is classified as UN 3480 (lithium ion
batteries) and has been tested pursuant to UN Manual Tests
and Criteria Part III, Subsection 38.3.
The transport regulations can be found in
www.stihl.com/safety-data-sheets.
13 Changing the Blower for Use as a
Vacuum Shredder
14 After Finishing Work
0000097247_001
15 Transporting
To Next Page
Loading...
