Stihl SHA 56 - Specifications; Vacuum Shredder STIHL SHA 56; STIHL AK Battery; Sound Values and Vibration Values

0458-828-9621-B
45
English 19 Troubleshooting
19.1 Remedying Faults in the Blower or Battery
19 Troubleshooting
Fault LEDs on the
battery
Cause Remedy
The vacuum
shredder does not
start when switched
on.
1 LED flashing
green.
State of charge of the
battery is too low.
► Charge the battery.
1 LED emits red
light.
The battery is too warm or
too cold.
► Remove the battery.
► Allow the battery to cool down or warm up.
3 LEDs flashing
red.
There is a fault in the
vacuum shredder.
► Remove the battery.
► Clean electrical contacts in the battery
compartment.
► Insert battery.
► Switch the vacuum shredder on.
► If 3 LEDs continue to flash red: Do not use the
blower and contact your STIHL dealer for
assistance.
3 LEDs light
up red.
The vacuum shredder is
too hot.
► Remove the battery.
► Wait for the vacuum shredder to cool down.
4 LEDs flashing
red.
There is a fault in the
battery.
► Remove battery and reinsert it.
► Switch the vacuum shredder on.
► If 4 LEDs continue to flash red: Do not use the
battery and contact your STIHL dealer for
assistance.
No electrical contact
between the vacuum
shredder and the battery.
► Remove the battery.
► Clean electrical contacts in the battery
compartment.
► Insert battery.
The vacuum shredder or
battery is damp.
► Allow the vacuum shredder or battery to dry.