0458-828-9621-B
46
English
19 Troubleshooting
The vacuum
shredder cuts out
during operation.
3 LEDs light
up red.
The vacuum shredder is
too hot.
► Remove the battery.
► Wait for the vacuum shredder to cool down.
There is an electrical fault. ► Remove battery and reinsert it.
► Switch the vacuum shredder on.
The vacuum shredder is
clogged.
► Remove the battery.
► Clean the vacuum shredder.
The suction power is
too low.
The catcher bag is full or
dirty.
► Remove the battery.
► Empty the catcher bag.
► Clean the catcher bag.
The suction tube or blower
wheel is clogged.
► Remove the battery.
► Clean the vacuum shredder.
The runtime of the
vacuum shredder is
too short.
The battery is not fully
charged.
► Fully charge the battery.
The battery service life has
been exceeded.
► Replace battery.
Charging does not
start when the
battery is inserted
into the charger.
1 LED emits red
light.
The battery is too warm or
too cold.
► Leave battery inserted in charger.
Charging starts automatically as soon as the
permitted temperature range is reached.
Fault LEDs on the
battery
Cause Remedy
To Next Page
Loading...
