TS 440
English
2
Pictograms
The meanings of the pictograms
attached to or embossed on the
machine are explained in this manual.
The following pictograms are on your
machine.
Symbols in Text
Many operating and safety instructions
are supported by illustrations.
The individual steps or procedures
described in the manual may be marked
in different ways:
N A bullet marks a step or procedure.
A description of a step or procedure that
refers directly to an illustration may
contain item numbers that appear in the
illustration. For example:
N Loosen the screw (1).
N Lever (2) ...
In addition to the operating instructions,
this manual may contain paragraphs
that require your special attention. Such
paragraphs are marked with the
symbols and signal words described
below:
DANGER
Indicates a hazardous situation that, if
not avoided, will result in death or
serious injury.
WARNING
Indicates a hazardous situation that, if
not avoided, could result in death or
serious injury.
NOTICE
Indicates a risk of property damage,
including damage to the machine or its
individual components.
Engineering Improvements
STIHL’s philosophy is to continually
improve all of its products. As a result,
engineering changes and improvements
are made from time to time. Therefore,
some changes, modifications and
improvements may not be covered in
this manual. If the operating
characteristics or the appearance of
your machine differs from those
described in this manual, please contact
your STIHL dealer or the STIHL
distributor for your area for assistance.
WARNING
Careless or improper use of any cut-off
machine may cause serious or fatal
injury.
Have your STIHL dealer show you how
to operate your cut-off machine.
Observe all applicable national, state
and local laws, safety regulations,
standards and ordinances.
WARNING
Your cut-off machine is for professional
use only. Do not lend or rent your cut-off
machine without the instruction manual.
Be sure that anyone using it
understands the information contained
in this manual.
Guide to Using this Manual
Fuel tank for gasoline
and engine oil mixture
Press to operate manual
fuel pump
Pull brake lever toward
the front handle to
release the wheel brake
Safety Precautions and
Working Techniques
The use of any cut-off
machine may be hazard-
ous. Because a cut-off
machine is a powerful
cutting tool that often cre-
ates sparks during the
cutting process, special
safety precautions must
be observed to reduce
the risk of personal injury
and fire.
It is important that you
read, fully understand
and observe the following
safety precautions and
warnings. Read the
instruction manual and
the safety precautions
periodically.
To Next Page
Loading...
