Stihl TS 440 Instruction Manual

TS 440
English
52
STIHL offers diamond cutting wheels
that are suitable for cutting the following
materials with the TS 440:
– Asphalt
– Concrete
– Stone (hard rock)
– Abrasive concrete
– Green concrete
– Clay bricks
– Clay pipes
– Ductile iron
– Structural steel up to 10 mm thick
For more information and a full list of
approved cutting attachments see your
authorized STIHL dealer.
Users of this unit should carry out only
the maintenance operations described
in this manual. STIHL recommends that
other repair work be performed only by
authorized STIHL servicing dealers
using genuine STIHL replacement parts.
Genuine STIHL parts can be identified
by the STIHL part number, the
{ logo and, in some cases, by
the STIHL parts symbol K. The
symbol may appear alone on small
parts.
For repairs of any component of this
unit’s air emissions control system,
please refer to the air emissions
systems warranty in this manual.
Observe all country-specific waste
disposal rules and regulations.
STIHL products should be disposed of in
approved disposal sites for recycling.
Contact your authorized STIHL
servicing dealer for the latest information
on waste disposal.
Diamond cutting wheels
Minimum outside diameter of
thrust washers:
4.06 in.
(103 mm)
Max. possible depth of cut: 4.9 in.
(125 mm)
Maintenance and Repairs Disposal
000BA073 KN

Stihl TS 440 Specifications

General

Engine Power	3.2 kW
Cutting Wheel Diameter	350 mm
Maximum Cutting Depth	125 mm
Arbor Size	20 mm
Cutting Depth	125 mm
Vibration Level Left/Right Handle	3.9/3.9 m/s²
Displacement	66.7 cc
Fuel Capacity	710 cc
Fuel Tank Capacity	710 cc