Stihl TS 500i - Mounting an Abrasive Cutting Wheel

TS 480i, TS 500i
English
33
N Insert the square nut into the guide
in the guard and hold it in place
N Screw in the shorter banjo bolt (6)
and washer at the adjusting lever
and tighten up with the combination
wrench
Mounting "cast arm with guard" – guard
on the outboard side
N Press the oblong holes (1) in the
"cast arm and guard" on to the
studs (2), guiding the ribbed V-belt
over the front pulley
NOTICE
The belt action must run smoothly.
N The belt tensioner (3) must sit close
to the lug (4)
N Fit the "starter cover with rewind
starter" (5) over the studs (2)
N Tighten up the nuts (6) by hand
N Push the V-belt guard (7) into place
N Screw in the bolt (8) and tighten up
Connecting the water connection
N Insert the longer banjo bolt (1)
through the connector (2) of the
water attachment – observe the
position of the connector
N Insert the square nut into the guide
in the guard and hold it in place
N Fit the support with the longer banjo
bolt on the adjusting lever (3) –
screw in the banjo bolt and tighten
with the combination wrench
N Insert the water hose into the guide
in the V-belt guard (arrow) from the
water connection towards the guard
– avoid tight radiuses
Checking the adjustment range of the
guard
N Rotate the guard forwards and
backwards as far as possible –
adjustment range (A) must be
limited by the stop pin
Continue as described in the chapter
“Tensioning the V-belt.”
2
2
3
4
1
2
1
1
1307BA007 KN
2
6
6
2
1307BA008 KN
2
5
6
7
8
1307BA009 KN
1
1
370BA078 KN
2
3
A
1307BA010 KN