CAUTION
In a dangerous situation, the driver can apply forced
braking by placing the operating lever in the braking
position, or by using reverse braking, depending on
the actual situation.
Creep speed switch
– Keeping the handle in the vertical position,
simultaneously press the drive switch (4)
and the creep speed switch (5); the truck
will reduce its speed to 20% of the maxi-
mum speed.
Using the truck on a slope
NOTE
Incorrect use of the truck on slopes is not rec-
ommended. It places particular stress on the
traction motor, brakes and battery.
Be particularly careful near slopes:
●
Never attempt a slope with a gradient great-
er than that specified in the truck's data-
sheet.
●
Make sure that the ground is dry with a non-
slip surface and that the route is clear.
Operation
4
Drive system
495001 801 1532 EN - 10/2021 - 03
To Next Page
Loading...
