EasyManua.ls Logo

Still ECH 12C - Forklift Truck Transport

Still ECH 12C
114 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3. Check the reliability of the charging device
and make sure that the charging device is
charging in full compliance with the voltage
and current regulation signals from the BMS.
Make sure that the battery will not be over-
charged (once per month);
4. Check the discharge protection devices
such as fast-acting fuses, DC contactors and
relays. Make sure that the main circuit of the
battery module can be quickly disconnected in
the event of dangerous situations such as
short circuit or overcurrent (once per month);
5. Check the status of the insulation resist-
ance of the battery module and the bodywork,
and make sure that the resistance complies
with the DIN 43539, VDE 0510,in order to
prevent battery leakage (once per month);
Disposing of used batteries
In order to prevent environmental pollution,
used batteries should be sent to local battery
recycling/disposal centres or professional lithi-
um battery disposal organisations, Observe
the regional and national regulations.
Forklift truck transport
Only use haulage equipment with sufficient
load capacity. (For loading and unloading
weights, see the truck model nameplate
and vehicle parameters).
The load weight is greater than the net
weight of the truck (including battery
weight). The load weight does not just in-
clude the net weight of the truck; it also in-
cludes the wooden pallet.
The pallet (or wooden box) should be large
and strong enough to withstand the weight
of the truck.
Follow the prescribed steps and park the
vehicle correctly.
Make sure the forks are aligned with the
pallet, move slowly and stop after inserting
the forks as far into the pallet as possible.
NOTE
Pay attention to the fork blades when lifting
the truck onto the pallet, to prevent injuries
caused by the fork blades trailing on the
ground.
Transport on a spacious and level surface
to avoid damaging the truck.
Be mindful of surface conditions when rais-
ing and lowering the pallet to avoid tipping
the truck.
The truck should be protected against rain.
Operation
4
Forklift truck transport
78 5001 801 1532 EN - 10/2021 - 03

Table of Contents

Related product manuals