– Make sure that the charger is not connected
to the circuit before connecting or discon-
necting it.
– The safety regulations supplied by the bat-
tery and charger manufacturer must be
strictly observed.
Charging procedure
– Ensure that charging requirements are
complied with.
– Park the truck as specified.
– Remove the key switch (1) to turn off the
power, and then take the plug-in lithium-ion
battery out before charging.
CAUTION
The charging voltage range is 100–240 V, 50–60 Hz.
Do not exceed this voltage range.
CAUTION
When charging and maintaining the battery, observe
the manufacturer's maintenance instructions for the
battery and battery charger.
Disassembling and installing the
battery
Before disassembling and installing the bat-
tery, you must raise the forks to the highest
position and then turn off the truck's power
supply.
Disassembly/installation steps:
Operation
4
Battery Use and Maintenance
62 5001 801 1532 EN - 10/2021 - 03
To Next Page
Loading...
