– Adjust the height of the forks until they can
be easily inserted into the pallet.
– Insert the forks under the load.
– If the load is shorter than the forks, position
the forks so that the front of the load over-
hangs them by a few centimetres, to avoid
interference with the load immediately
ahead.
– Raise the load a few centimetres above its
support.
– Back the truck away from the stack or any
neighbouring loads, gently and in a straight
line.
Transporting loads
– Always carry loads in the forward direction
of travel (A) in order to have the best visibili-
ty.
– When carrying a load on a slope, always
ascend or descend with the load uphill.Nev-
er drive sideways across a slope or perform
a U-turn.
– Reverse travel (B) is to be used solely for
unloading.Since visibility is reduced when
travelling in this direction, drive only at very
slow speed.
Operation
4
Load handling
555001 801 1532 EN - 10/2021 - 03
To Next Page
Loading...
