Still ECU-25 - On-Board Battery Charger (Optional)

Entering a password (Pin Code) for the oper-
ator
●
The four-digit user password for the first
start-up is factory-set and is:
1234. We rec-
ommend that the person responsible for op-
erators change this password and personal-
ise it as follows:
●
Enter the password of the person responsi-
ble for operators (Master Code) (for the first
time memorised, the password is the one
set by the factory:
111111 ) and press the
key (OK). The green LED (A) turns off and
the yellow LED turns on(D).
●
Using the keyboard, enter the control code
'
33' and press the key (OK). The yellow
LED (D) will begin to flash.
●
Enter a new four-digit password for the op-
erator (Pin Code) and press the key (OK).
●
At the end of the procedure, the green LED
(A) comes on and remains lit.
●
In the case of an error in the procedure, the
red LED (B) comes on and the numerical
keypad emits an acoustic warning signal,
after which the green LED (A) comes on
and remains lit. Repeat the procedure
Cancelling an operator password (Pin Code)
●
Enter the password of the person responsi-
ble for operators (Master Code) (for the first
time memorised, the password is the one
set by the factory:
111111 ) and press the
key (OK). The green LED (A) turns off and
the yellow LED turns on(D).
●
Using the keyboard, enter the control code
'
13 ' and press the key (OK). The yellow
LED (D) will begin to flash.
●
Enter the operator's password to be cancel-
led (Pin Code) and press the key (OK).
●
At the end of the procedure, the green LED
(A) comes on and remains lit.
●
In the case of an error in the procedure, the
red LED (B) comes on and the numerical
keypad emits an acoustic warning signal,
after which the green LED (A) comes on
and remains lit. Repeat the procedure
Cancelling all the operator passwords (Pin
Code)
●
Enter the password of the person responsi-
ble for operators (Master Code) (for the first
time memorised, the password is the one
set by the factory:
111111 ) and press the
key (OK). The green LED (A) turns off and
the yellow LED turns on(D).
●
Using the keyboard, enter the control code
'
22 ' and press the key (OK). The yellow
LED (D) will begin to flash.
●
Enter the password of the person responsi-
ble for the operators (Master Code) and
press the key (OK).
●
At the end of the procedure, the green LED
(A) comes on and remains lit.
●
In the case of an error in the procedure, the
red LED (B) comes on and the numerical
keypad emits an acoustic warning signal,
after which the green LED (A) comes on
and remains lit. Repeat the procedure
WARNING
This procedure cancels all of the operator passwords
(Pin code) memorised, including the factory-set
password (1234).
On-board battery charger (op-
tional)
Read the User and maintenance manual.
Knowledge of the truck
3
On-board battery charger (optional)
3345628043302 EN - 11/2021 - 07