Reversing the direction of travel
Reverse direction without a load on the
forks
●
To reverse direction when travelling without
a load on the forks, turn the drive control
throttle in the opposite direction to the direc-
tion of travel. The truck will stop with ener-
getic but gradual braking and will start to
move again in the opposite direction.
Reverse direction with a load on the
forks
●
To reverse direction with a load on the
forks, put the drive control throttle in the
neutral position and wait for the truck to
stop.
●
Then turn the drive control throttle in the op-
posite direction of travel to the previous
one.
CAUTION
The operator must regulate the travel control by
adapting truck braking to the type of load being car-
ried in order to avoid losing the load.
Forklift Braking/Stopping
The forklift can be braked by:
●
Releasing the tiller.
●
Reversing the direction of travel using the
traction control throttle.
NOTE
When the truck is stationary, the parking brake
takes over through the electromagnetic brake.
Parking and stopping the truck
●
Park in pre-arranged and designated areas
●
Lower the fork arms to the ground.
●
Release the tiller to activate the parking
brake
●
Switch off the truck: turn the key to position
"0" and remove the key from the panel, or
alternatively switch off the truck by means
of the numeric keypad (Digicode) if availa-
ble
Use and operation
4
Using the truck
4745628043302 EN - 11/2021 - 07
To Next Page
