Instructions for ECU 16–18–20 version
●
Turn off the truck and perform the prelimi-
nary maintenance operations.
●
Raise the battery compartment hood (1).
●
Disconnect the plug (2) from the outlet (3).
●
Insert the sling hooks in the two battery
points (4). The entire sling must be suitably
sized for the weight of the battery.
●
Lift the battery using a hoist suitably sized
for the weight of the battery.
●
Change the battery and refit it by following
the above steps in the reverse order.
CAUTION
To decide which type of battery to use, check the
battery characteristics provided in the "TECHNICAL
DATA" chapter.
DANGER
Use a crane with a suitable lifting capacity for the
weight of the battery. Lifting operations must be
performed by qualified personnel. DO NOT stand
within the crane's radius of action or near the truck.
Do not stand in the danger area beneath suspen-
ded loads. Use NON-METALLIC slings. Make sure
that the lifting capacity of the slings is suitable for
the weight of the battery. The rope slings must be
pulled vertically. To prevent short circuits, it is rec-
ommended that batteries with polar terminals or un-
protected connections be covered with a rubber
mat.
4
1
OM1778
3
2
Maintenance
5
Maintenance as required
64 45628043302 EN - 11/2021 - 07
To Next Page
Loading...
