digiConnect Windows® Software
digifobpro User Instructions Page - 14
Minimum Recommended PC Specification
Processor: Intel P4 1.4GHz, AMD Athlon 1.4 GHz
Memory: 512Mbytes
Hard disk: 40 Gbytes
Video Resolution: 1024 x 768
Operating Systems: Windows 7 / Windows 8 / Windows 10
digiconnect is pre loaded onto the digifobpro. Simply connect the
digifobpro to a free USB socket and use Windows Explorer to navigate to
the software directory.
Installing the digiConnect Windows® Software
1. Please browse to the USB flash drive of your digifobpro using
Windows® Explorer and double-click Setup.exe.
2. You will be prompted for your appropriate language. Please select
from the list and then click OK.
3. You will receive a welcome message, simply click ‘next’.
4. Read the terms of the Licence Agreement then click on the ’I accept
the terms in the Licence agreement’ option and then click ‘next’. If
you choose to not accept the terms the installation will be terminated.
5. Choose the folder in which you wish the software program files to be
installed. The default folder is the standard location for Windows®
programs. Click ‘next’.
6. Click ‘Install’ to begin the actual installation. This may take several
minutes.
7. Finally tick or untick the box labelled ‘Launch digiConnect ’ depending
on whether you wish to start the program on completion of the
installation. Click ‘Finish’.
8. If you opted to launch digiConnect at the end of the installation then
you will be taken to the main options menu to configure your individual
settings.
digiConnect Windows® Software - V5.00 onwards
To Next Page
Loading...
