digifobpro User Instructions Page - 23
Disclaimer
The digifobpro includes infringement checking designed to comply with
European legislation. This is with the following caveats:
The interpretation of the driving and rest times, speed information and
information about possible tampering with the digital tachograph is carried
out by national supervisory authority officials on the basis of Regulation (EC)
No. 561/2006 of 15.03.2006 (Driving and Rest Time regulation) and Regulation
(EC) No. 1360/2002 of 13.06.2002 (Recording Equipment in Road Transport).
With the implementation of these regulations into national law, there is some
room for interpretation which can lead to differences from country to
country.
Whilst infringement checking on digifobpro can provide a quick check it
cannot replace a comprehensive review carried out by the national
supervisory authorities. There are various interpretations and deviating
applications of the above regulations which are beyond the sphere of
influence of the manufacturer. Accordingly, neither the manufacturer nor its
distribution network will be held liable for fines validated by an authority.
The manufacturer or its sales channel assumes no liability for any loss that
may arise from use of the device.
Events and Faults
Please note! Council Regulation (EC) No. 2135/98 and its Annex 1 (B) sets out
exactly which faults and events should be recorded by a Vehicle Unit. In
essence the nature of the data recorded within these categories may help to
identify tampering with either the tachograph unit or its sensors or may help
to diagnose a fault within the tachograph or sensors. The list of possible
faults is extensive and they have therefore been grouped into categories. You
may wish to refer to Annex 1 (B) or your Tachograph user guide for further
information on Events and Faults..
To Next Page
Loading...
