STONEX R180 - Page 12

Stonex R180 – User Manual 12
Charging
Follow the instructions below to recharge R180 batteries.
Charge the Battery
a. Remove the charger and the cable from
the carrying case. Insert the charger cable
(A) in the battery hole (B).
b. Insert the cable plug (D) into the charger
(C)
c. Insert the plug (E) in the electrical outlet.
If the battery is not fully charged, the
charger will begin charging the battery
and the charger indicator will be in red
until the complete charge. When
charging is complete, the charger
indicator will be fixed green, disconnect
the battery from the charger, and then
you can install it or use it as a backup
battery.
Note. Please use charger and battery from STONEX. Store, use and charge at the specified temperature
conditions, taking care to avoid contact with liquids.