STONEX S900T - Interfaces; Control Panel

Stonex S900T GNSS Receiver – User Manual 3
1.2 Interfaces
The bottom interface of the instrument is shown below, and the protective
plug covered on it is used for the dustproof and waterproof of the external
interface. The TNC connector is used to connect to the built-in radio
antenna. The five-pin LEMO connector is used to connect external power
supply or external radio. The seven-pin LEMO connector is used for data
communication (data communication between the receiver and the
computer and the handbook).
Figure 1.2.1 UHF interface Figure 1.2.2 5pin LEMO interface
Figure 1.2.3 7pin LEMO interface
1.3 Control panel
The control panel is showed in Figure 1.3.1.
Figure 1.3.1 control panel