STONEX S990A - IMU with Stonex Cube-A; Sensor Activation and Configuration

Stonex S990A GNSS Receiver – User Manual v1.0 35
8.1 IMU with Stonex Cube-a
8.1.1 Sensor Activation and Configuration
To use the S990A with new IMU technology it’s necessary to enable the feature
in the specific options menu.
Before using the receiver to collect points with the slanted pole, check if the
pole tilt correction functionality has been enabled.
With Stonex Cube-a, follow this path to find the configuration menu:
Configure  System Settings  Sensor Options.
There, enable the Pole Tilt Correction.