strex SP50 - Persons & Use Restrictions; Electronics Safety and Handling

68
PERSONS & USE
ELECTRONICS
● The OBD2 Scanner is not a toy. Keep and store it out of the reach of small children.
● The device may only be used by adults.
● This appliance is not intended for use by persons with reduced physical, sensory, or mental
capabilities, or lack of experience and knowledge unless they have been given supervision or
instruction concerning the use of the appliance by a person responsible for their safety.
● You may not reconstruct, self-repair, or disassemble the OBD2 Scanner. This can damage the
device.
● Maintenance, modications, and repairs may only be carried out by the manufacturer, a
professional workshop appointed by the manufacturer, or a similarly qualied person.
● Check the device from time to time for damage. Never use the device if it shows signs of
damage.
● Do not use any other connector for this device. This can cause failure and/or damage.
● Make sure your vehicle battery supplies the correct power voltage to avoid damage to the
device.
● Disconnect the device if you do not use it for an extended period, and before cleaning.
● Never force the connector of the device into the vehicle’s Data Link Connector (DLC); if it does
not t easily into the DLC, stop using it. Always make sure that the connector of your device is
properly connected to the DLC.
● If the power fails during the operation, turn o the device immediately and pull the connector
from the DLC.
● If smoke is produced, or there are any unusual sounds or smells, switch o the OBD2 Scanner
immediately and remove the connector from the DLC. In these cases, the OBD2 Scanner should
not be used until it has been inspected by the manufacturer, or a similarly qualied person.
Never inhale smoke from a potential device re. If you have inhaled smoke, however, consult a
doctor. The inhalation of smoke can be harmful.