Strong SRT 3002 - Connecting to TV with SCART Cable; Connecting to a Digital Audio Amplifier with S;PDIF; Connecting to a Digital Audio Amplifier and TV Using HDMI; Connecting a USB Storage Device

3.3 Connecting to TV with SCART cable
Fig. 6
Your receiver is also equipped with a SCART connector; alternatively, the TV set can be connected to the receiver using
a good quality SCART cable.
3.4 Connecting to a Digital Audio Amplier with S/PDIF
Fig. 6
By connecting your receiver to a digital amplifier or home theatre system, you can enjoy the best possible sound
quality and multi-channel audio (depending on the broadcast). Connect your Digital Audio Amplifier or home theatre
system with a suitable cinch cable to the S/PDIF connector on the back of the receiver.
3.5 Connecting to a Digital Audio Amplier and TV using HDMI
Fig. 7
By connecting your receiver to the latest digital amplifiers or Home Cinema systems you will enjoy the best possible
sound quality and multi-channel audio (depending on the broadcast). Connect the HDMI output of the receiver to an
input of your amplifier, and then connect the HDMI output of the amplifier to your TV set. Select the correct input on
your amplifier to watch and listen to programmes.
3.6 Connecting a USB storage device
Fig. 8
Connecting a USB device to the unit allows you to record TV programmes*, playback movies, music and picture files.
See chapter 7.5.1.
NOTE It is recommended to use USB 2.0 storage devices or higher for playback of recordings or HD
movies.
NOTE Timeshift/recording and playback only works properly when a fast USB storage device such
as a USB 2.0 HDD is connected to the receiver. Timeshift/recording and playback of HD
content requires a sufficient continuous read/write speed of the used USB storage device. *
*This user manual describes the full functionality including the recording function and may not be applicable if the software for recording via
USB has not yet been installed.
4.0 STARTING UP FOR THE FIRST TIME
When you use your receiver for the first time, the Welcome menu appears. Use p/q to move the highlight to the
setting you wish to alter and use tu to change values. Start by selecting your language using tu. Once you have
selected your language, press q to move the highlight to the next item and use tu to change.
Region: Select your region where this receiver is used.
Language Here you can choose your language.
Aspect Mode: Use this option to select the aspect ratio of your TV and the preferred conversion method.
The options are: Auto (automatic detection of aspect ratio), 4:3PS (Panscan) (Displays 16:9
widescreen broadcasts full screen on your 4:3 TV), 4:3LB (letterbox) (black bars on top and
under the picture on a 4:3 TV) and 16:9 (use this setting for 16:9 TV sets).
Subtitle Display: Select On to display subtitles per default. Select Hard of Hearing or Normal to show Hard of
Hearing or Normal subtitles per default. Select Off to hide subtitles per default.
Scan mode: Select All to store scrambled and free to air channels or select Free to store only free to air
channels. Note: Scrambled channels can’t be opened/watched with this receiver.
Provider: Select the “Provider” (Broadcaster, cable network) of your local cable system. If unknown, select
other. From the main menu Installation, more options are available to do different scan types.
When all settings have been made, move the highlight to Search and press OK to continue.
7
English