Use p/q to select Load Factory Settings in the Tools menu and press OK. You are asked to input your PIN code.
Input the correct PIN code using the 0~9 (DEFAULT PIN: 1234). A confirmation window is displayed.
Select Yes to return to factory settings.
The receiver will return to its initial state and show the Welcome page.
Select No to cancel.
Press ļ to leave.
7.4.3 Upgrade by USB
This feature allows you to upgrade receiver software via the USB port. When new software is available for your receiver,
it can be downloaded from our website www.strong.tv.
Place the software file (unzipped) in the root directory of your USB storage device (HDD, memory stick etc.) and connect
the device to the USB port of the receiver.
Select Upgrade by USB from the Tools menu and press OK to proceed.
The upgrade menu will now be displayed.
Use p/q to select Upgrade Mode and choose option Allcode.
Use p/q to select Upgrade File and choose the file containing the latest and correct software.
When all settings have been made, move the highlight to Start and press OK to start the upgrade process. The receiver
will show a warning message.
Select Yes to finalize the upgrade or No to quit without upgrading.
NOTE: If, after a software upgrade, the receiver should behave in an unexpected way, please
perform a factory reset as well. See chapter 7.4.2.
Warning! Be sure to have the correct software update for your brand and model available. Trying to
update to any other software may damage the unit and will void the warranty. After an
update the receiver restarts automatically. During the upgrade process NEVER disconnect the
receiver from the mains or switch off the power! Doing so might damage your receiver and
will void warranty!
Channel Dump and Load function
This feature allows you to load a channels list quickly and use a channel list that previously was created on this (backup)
or another receiver from the same model via the USB port.
This is useful when more receivers have to be installed on the same network, thus omitting a full scan and (optional)
sorting of channels. It is also useful as a backup for your own unit.
Channel Dump function (backup to USB)
Have a storage device connected to the USB port of the receiver. Select Upgrade by USB from the Tools menu and press
OK to proceed. The upgrade menu will now be displayed.
Use pq to select Upgrade Mode and choose the option Dump channel list.
A DataBase file name containing date and time will be presented, format DBMMHHDDMMYYYY
(DatebaseMinuteHourDayMonthYear.udf).
Use pq to select Start and press OK to proceed. The channel list and favourites will be saved.
Update Channel list function (load from USB)
Have the storage device connected to the USB port of the receiver, containing a previously made channel list on this
unit or another of the same model. Select Upgrade by USB from the Tools menu and press OK to proceed. The upgrade
menu will now be displayed.
Use pq to select Upgrade Mode and choose the option Update Channel list.
Use pq to select Upgrade File. Select the correct database file name, format DBMMHHDDMMYYYY
(DatebaseMinuteHourDayMonthYear.udf).
Use pq to select Start and press OK to proceed. Confirm the upgrade with OK to proceed.
16
To Next Page
Loading...
