Do not put the battery into re, and charge or decompose the battery.
Please dispose batteries abide by relevant environmental protection regulation.
2.7 Using the remote control
Use the remote control by pointing it towards the remote sensor. Items between the remote
control and the remote sensor could block normal operation.
Do not cause the remote control to vibrate violently. Also, do not splash liquid on the remote
control, also do not put the remote control in a high humidity place.
Do not place the remote control under direct sunlight which will cause deformation of the unit
by heat.
When the remote sensor is under direct sunlight or strong lighting, the remote control will not
work. If so, please change the lighting or TV's position, or operate the remote control closer to
the remote sensor.
3.0 FIRST TIME INSTALLATION
After all connections have been made properly, switch on your TV. Insert the main power plug i nto the
wall outlet, now the red LED light should light up. Press the q button on your remote control to wake
the TV up. The language and country selection will appear on the screen. Use to select the OSD
Language of your preference. Use to select the Country and use again to select the region you
are using this TV. This country/region selection is an important setting, it will set the time zone and will
try to sort region channels at rst or in a speci c order.
Use to enter the Environment menu, here you can choose between Home Mode or Shop Mode. The
Shop Mode is for demonstration purpose (e.g. in a shop), it will turn the ECO setting o and the screen to
a higher level.
If all settings are made, con rm with OK on your remote control and follow the next steps.
On the next screen, you can select which tuner you like to use and which channels you'd like to search
for. Choose Tuner Type and by pressing you can choose between DTV, ATV or DTV + ATV (DTV to
search digital broadcasts; ATV to search analogue broadcasts). After you made your selection, press to
proceed to Digital type. In this menu you can select which input source you would like to use:
Satellite to receive satellite broadcasts (if you are equipped with a satellite dish)
DVB-T to receive terrestrial broadcasts (by using indoor or outdoor antenna)
DVB-C to receive cable broadcasts. (Connection to cable outlet box)
Then the next screen appears depending from the tuner selection you choose.
3.1 DVB-S/S2 installation
Satellite Setting
Press to select the satellite your dish is aimed at. Use the buttons to change settings for
your satellite installation for each speci c satellite.
Channel Search
Press to highlight the options of choice and press OK to start the channel search.
Scan Mode Choose between Default (recommended), Blind Scan and Network
Channel Type Select Free to search Free-To-Air channels only,
Select Scramble to search Encrypted channels only, All Channels to search FTA
and Encrypted channels.
7
English
To Next Page
Loading...
Need help?
General
