5.2.2 Colour Temperature
In this menu you can change the overall colour cast of the picture.
Press to select Colour Temperature, then press OK to enter a sub-menu. Press to select the
relevant picture e ect (DEFAULT: Cold Normal Warm).
Cold lncrease the blue tone for the white.
Normal Increase the neutral colours for the white.
Warm lncrease the red colour for the white.
5.2.3 Noise Reduction
In this menu you can lter out and reduce the image noise and improve picture quality. Press to
select Noise Reduction, then press OK to enter a sub-menu.
O Select to turn o video noise detection.
Low Detect and reduce low video noise.
Middle Detect and reduce moderate video noise.
High Detect and reduce enhanced video noise.
Default Set as Default.
5.3 Sound menu
Sound Mode Select your favourite sound mode for each input. Choices are Standard, Music,
Movie, Sports and User.
Bass Adjusts the lower frequency of the sound.
Treble Adjusts the higher frequency of the sound.
Balance Control the sound balance between the right and left loudspeaker
(earphone).
Enjoy Music Turns o the screen or switch to music source when it will be found on HDMI
input.
Auto Volume Adjust the volume corresponding to the input audio level. Options are On
and O .
S/PDIF Type If you have connected S/PDIF output to digital home audio system. You can
select “Auto” to output Dolby audio* automatically. If channel have this audio
channel. Selection PCM is only stereo audio and O is to switch o this output.
AD Switch Turn on the Audio description, you can activate the setting of AD volume.
When turn on the audio description, a narrator will describe what is
happening on the screen for blind or visually impaired viewers. (Only if
available in DTV mode.)
*Availability depending on broadcaster
5.4 Installation
Press MENU to display the main menu. Press to select Installation in the main menu. Press OK it
access and press to select the option you wish to adjust in the Installation menu. Press OK to enter
and to adjust.
Below items depend if they are available of select input source. Use SOURCE to select other source.
10
To Next Page
Loading...
