Scan type Select which input source you want to use: DVB-S to receive satellite
broadcasts (and if you are equipped with a satellite dish), DVB-T to receive
terrestrial broadcasts or DVB-C to receive cable broadcasts.
3.1 DVB-S/S2 installation
Satellite Setting
First select th e region where you are using the TV. This important to set time zone correct. Use the
and con rm with OK.
Press to highlight the satellite your dish is aimed at. Con rm with OK to mark the satellite. Use
the buttons to change settings for your satellite installation for each speci c satellite. The
signal quality bar on the bottom of the screen allows you to ne tune the alignment of your antenna for
optimum reception. Adjust your antenna for maximum possible signal quality. When the signal cannot
be improved anymore, x the dish on this position and press the BLUE Scan button to continue.
Channel Search
Press to highlight the options of choice and press OK to start the channel search.
Scan Mode Choose between Default (recommended), Blind Scan, Network and Preset
Channel List.*
Crypted Select FTA Channels to search Free-To-Air channels only or All Channels to
search FTA and Encrypted channels
Service Type Select DTV to search DTV channels only, RADIO to search radio channels only
or All for a complete search.
It is recommended to use the default settings.
3.2 DVB-T/T2 in stallation
Terrestrial Setting
First select the Tune Type by pressing to select DTV, ATV or DTV+ATV (DTV to search digital
broadcasts and ATV to search analogue broadcasts). Press to continue. Press to select All
Channels or FTA Channels. Press to highlight the country that you want to install, then press OK
to start searching.
3.3 DVB-C insta llation
Cable Setting
Press to highlight your settings.
Scan type You can select Network Scan or Full. (Default Network Scan for quick search
advised)
NOTE: Full scan will have a duration of approximately 20 minutes, depending on
your cable network.
Frequency Please enter (with 0 ~ 9) the main frequency used by your provider in KHz.
Network ID Please enter (with 0 ~ 9) the used Network ID from your provider.
Symbol Please enter (with 0 ~ 9) the used Symbol from your provider. (Ks/s)
8
To Next Page
Loading...
Need help?
General
