PART 1 • English
8
Use BLUE to set the scan type to NIT OFF or NIT ON if Blind Scan is set to OFF or to Quick Search
or Detail Search if Blind Scan is set to ON.
Once set-up is completed, press RED to start the scan.
5.2.3 Manual Scan
In Manual Scan you can scan a single transponder, add a new transponder, edit or delete a
transponder. Use the RED button to switch between satellites.
Scan transponder: Use pq to select the desired transponder. Press OK to start the scan.
Add Transponder: Press GREEN, the Add Transponder sub-menu will appear.
Frequency: input the frequency of the new transponder.
Symbol Rate: input the symbol rate of the new transponder.
Polarity: Select the Polarity of the new transponder.
Edit Transponder: Press YELLOW, the Edit Transponder sub-menu will appear. This menu is
similar to Add Transponder menu.
Delete Transponder Press BLUE to delete a transponder. You will be asked to confirm this
operation. Use tu to select OK, press OK to confirm.
5.3 System setting
Use this menu to configure system settings, such as Language Setting, OSD Style, Parental Control,
TV Settings and Time Setting.
5.3.1 Preference
5.3.1.1 Language Setting
Use this option to change the language of the OSD, preferred audio and subtitles.
Use pq to select OSD language, Audio language or Subtitles language. Press OK or u to enter the
language list and use pq to select the language. Press OK to confirm.
5.3.1.2 TV settings
Use this option to set the TV mode, Screen mode, Video output and Modulator settings*.
TV mode Press OK or u to select mode and OK to confirm. If you don’t know your
TV’s standard, select AUTO.
Screen mode Press OK or u to select 4:3 or 16:9 and OK to confirm.
Video output Press OK or u to select CVBS or RGB and OK to confirm.
Modulator settings* Use pq to select RF Audio mode or RF channel. Use tu to change the
settings and press OK to confirm or EXIT to cancel the settings.
* only SRT 6205
5.3.1.3 Time Settings
If a broadcaster provides GMT, you can set the time using GMT or set the time manually. If the
GMT usage is ON, you need to set the Time Zone. If you set GMT Usage to OFF, Set Data and Set
Time are displayed. To set the time value manually, move the cursor to the time item and use the
numeric buttons on the remote control.
To Next Page
