Strong SRT 6200 - Equipment Set-up; Your Receiver Overview; Rear Panel Connections

PART 1 • English
3
English
1.3 Equipment Set-up
We recommend you consult a professional installer to set up your equipment. Otherwise, please
follow the instructions below:
nRefer to the user manual of your TV and your antenna.
nMake sure that the SCART cable and outdoor components are in a good condition and
the SCART connections are well shielded
This manual provides complete instructions for installing and using this receiver. The following
symbols will serve as follow.
WARNING: Indicates warning information.
Tips: Indicates any other additional important or helpful information.
MENU Represents a button on the remote control or the receiver (Bold Character)
Move to Represents a menu item within a window. (Italic Character)
1.4 Accessories
nUser’s Manual
n1 Remote control unit
n2x Batteries (AAA type)
Note: The batteries should not be recharged, disassembled, electrically short-circuited,
be mixed or used with other types of batteries.
1.5 Usage of external USB devices
nIt is recommended to use USB 2.0 storage devices. If your device is not compatible
to USB 2.0 specifications, recording, playback and other multimedia functions of the
receiver would not work properly.
nTo ensure best performance of your USB storage device please format it by this receiver
(menu “Recording Device”) to FAT32 system. Other file systems are not supported by the
receiver.
nSTRONG cannot guarantee compatibility to all types of USB storage devices.
nIt is advised not to store important information on USB storage devices used with the
receiver. Always make backups of data on USB storage device before usage with receiver.
STRONG will not take responsibility for any loss of information or circumstances caused
by loss of information.
2.0 YOUR RECEIVER
2.1 Rear Panel
Fig. 2
1. TO TV To connect to your TV using a coaxial cable or if you have a cable
connected to the ANT input from your TV*
2. ANT IN To connect to your terrestrial antenna or cable TV using coaxial cable*
3. SAT OUT To connect an extra receiver to the satellite signal from dish
4. SAT IN To connect to the LNB for satellite signal from dish