PART 1 • English
5
English
4 Recording No function
1 Play
6 Fast backward
7 Fast forward
3 Stop
2.3 Default PIN code: 0000
3.0 CONNECTIONS
3.1 Basic connection with SCART cable
Fig. 4
3.2 Connecting to Satellite Dish
Connecting a fixed satellite dish to your receiver (Fig. 5)
Connecting multiple fixed dishes to your receiver using a DiSEqC 1.0 switch (Fig. 6)
3.3 Connecting USB device
Fig. 7
4.0 STARTING UP
Ensure your satellite signal is of good quality. It is recommended that you perform the first time
installation following the Installation Wizard step by step. It will help you to easily achieve system
configuration and channel installation.
4.1 Language Selection
Press pq to choose your language, press OK to confirm. The Select Satellite menu will appear.
Further installation steps are depending on the satellite where your dish is aimed at.
4.2 Select Satellite
a) Your dish is aimed at Astra 1C, 1E, 1F or HOT BIRD satellite.
Press pq to select the ASTRA or HOT BIRD satellite and press OK. Follow the instructions.
When you have fixed your dish at the correct position choose NEXT and press OK. The Channel
Setup menu will appear.
Note: If OSD language “German” and satellite “Astra 19.2E” is chosen, the receiver will
automatically load German pre-installed channels at the beginning of the channel list.
If OSD language “Italian” and satellite “HOT BIRD 13E” is chosen, the receiver will
automatically load Italian pre-installed channels at the beginning of the channel list.
b) Your dish is aimed at another satellite
Select Other in Select satellite menu and press OK. A list of satellites will be listed. If you select
one out of the satellite list, the Configure Antenna menu will appear. Use this menu to set the
To Next Page
Loading...
