Strong SRT 6200 - System Configuration and Updates

PART 1 • English
9
English
5.3.1.4 Auto Standby
This option allows you to set the desired Auto Standby time or to disable Auto Standby. Auto
Standby will switch the receiver to standby automatically when it doesn’t receive commands from
the remote control for a given period of time. Possible settings are: 1~6 Hours and Disable. The
default setting for Auto Standby is 3 hours. To avoid the automatic switch off, set Auto Standby to
Disable.
5.3.1.5 Set Factory Default
Please be careful when using this function, as it will erase all the data and parameters you may have
set earlier. Once you set the factory default you will have to re-install your preferences and re-scan
channels. To reset your receiver to factory default, apply the following steps:
Select Set Factory default and press OK. Confirm the warning message with OK and press OK. The
receiver will return to its factory default state and all user data will be deleted.
Note: IYour PIN code will change back to the factory setting “0000”.
5.3.2 OSD Style
Use this menu to set the Menu Colour, Transparency Level and Border Pattern.
5.3.3 Parental Control
Use this menu to set Channel lock status (ON or OFF), the Menu lock status, Parental setting and
Change PIN code. The default PIN code is 0000.
Channel Lock Set the system channel lock to ON or OFF. If lock is ON, a locked channel can only
be watched after entering the parental PIN.
Menu Lock Press OK to select whether the menu should be locked or not (YES or NO) and
press OK to confirm. If the menu lock is ON, some operations such as search
program and set factory default can only be accessed after entering the PIN.
Parental Setting If a channel is locked, it can only be watched after entering the parental PIN code.
Use pq to select the channel you wish to lock. Press OK to lock the channel.
Change PIN To change the PIN, please enter and re-enter the desired 4 digit code. The system
PIN will then be changed to the new PIN.
5.3.4 System info
Shows information about your receiver such as software and user interface version.
5.3.5 System Update
Options are: “OAD”, “Update by USB” or “Backup to USB”.
nOver Air Download (OAD)
Select this option in order to update your receiver with the latest software version.
Software update service is available from satellite ASTRA 19.2E.
Note: If needed, parameters can be changed. Please ask your local STRONG dealer in
case software update was not successful.
nUpdate by USB