PART 1 • English
8
5.3.1 Preference
5.3.1.1 Language Setting
You can change the language of the OSD, preferred audio and subtitles.
Use pq to select the OSD language, Audio language or Subtitles language. Press OK or u to enter
the language list and press pq to select the language. Press OK to confirm.
5.3.1.2 TV settings
You can set the TV mode, Screen mode and Video output settings..
TV mode Press OK or u to select mode and OK to confirm. If you don’t know which
standard your TV has, select AUTO.
Screen mode Press OK or u to select 4:3 or 16:9 and OK to confirm.
Video output Press OK or u to select CVBS or RGB and OK to confirm.
Modulator settings Use pq to select RF Audio mode or RF channel. Use tu to change the
settings and press OK to confirm or EXIT to cancel the settings.
5.3.1.3 Time Settings
If a broadcaster provides GMT, you can set the time using GMT or set the time manually. If the
GMT usage is ON, you need to set the Time Zone. If you set GMT Usage to OFF, Set Data and Set
Time are displayed. To set the time value manually, move the cursor to the time item and use the
numeric buttons on the remote control.
5.3.1.4 Auto Standby
This option allows you to set the desired Auto Standby time or to disable Auto Standby. Auto Standby
will switch the receiver to standby automatically when it doesn’t receive commands from the remote
control for a given period of time. Possible settings are: 1~6 Hours and Disable. The default setting
for Auto Standby is 3 hours. To avoid the automatic switch off, set Auto Standby to Disable.
5.3.1.5 Set Factory Default
Please be careful when using this function, as it will erase all the data and parameters you may have
set earlier. Once you set the factory default you will have to re-install your preferences and re-scan
channels. To reset your receiver to factory default, apply the following steps:
Select Set Factory default and press OK. Confirm warning message with OK and press OK. The
receiver will return to its factory default state and all user data will be deleted.
Note: IYour PIN code will change back to the factory setting “0000”.
5.3.2 OSD Style
You can set the Menu Colour, Transparency Level and Border Pattern.
5.3.3 Parental Control
You can set Channel lock status (ON or OFF), the Menu lock status, Parental setting and Change
PIN code. The default PIN code is 0000.
To Next Page
Loading...
