Strong SRT 6201 - System Info; System Update

PART 1 • English
9
English
Channel Lock Set the system channel lock to ON or OFF. If lock is ON, the parental PIN code
needs to be entered to watch the locked channel.
Menu Lock Press OK to select whether the menu should be locked or not (YES or NO),
press OK to confirm. If the menu lock is ON, you need to enter the PIN for some
operations such as search program and set factory default.
Parental Setting If a channel is locked, the parental PIN code needs to be entered to watch the
locked channel. Use pq to select the channel you want to lock. Press OK to lock
the channel.
Change PIN To change the PIN, you need to enter a 4 digits PIN and confirm it again. The
system PIN will be changed to the new PIN.
5.3.4 System info
It shows information about your receiver such as software and user interface version.
5.3.5 System Update
You can select “OAD”, “Update by USB” or “Backup to USB”.
nOver Air Download (OAD)
Select this option in order to update your receiver with the latest software version.
Software update service is available from satellite ASTRA 19.2E.
Note: If needed, parameters can be changed. Please ask your local STRONG dealer in
case software update was not successful.
nUpdate by USB
a) Download the required update file for your receiver model from our website www.
strong.tv > Support
b) Unzip the file, copy it to your USB device and connect it to the USB port of receiver.
c) Select “Update by USB” and the update file and press OK.
Do not power off your receiver during update process and flashing data. Do not
unplug the USB device during update. This may cause damage of the data in the flash
memory and the receiver will need to be repaired.
d) When update is completed, receiver returns to normal view and is ready to use.
nBackup to USB
Select this option in order to store your settings, channels or complete software.
This can be helpful to re-load your channels after a factory reset or to load the channel
order to more receivers.
a) Connect USB device to USB port of receiver.
b) Select “Backup to USB” and press OK.
c) Choose between “Loader + App” or “User Database” and press OK to start back-up.
“Loader +App” will backup system loader and application, while “User Database” will
backup channel database and settings.
Do not power off your receiver during update process and flashing data. Do not
unplug the USB device during update. This may cause damage of the data in the flash
memory and the receiver will need to be repaired.
d) When backup is completed, receiver returns to “System Update” menu.