Strong SRT 6201 - 4.0 Starting Up; 4.1 Language Selection; 4.2 Select Satellite; 4.3 Antenna mode

PART 1 • English
5
English
4.0 STARTING UP
Ensure your satellite signal is of good quality. It is recommended that you perform the first time
installation following the Installation Wizard step by step. It will help you to easily achieve system
configuration and channel installation.
4.1 Language Selection
Press pq to choose your language, press OK to confirm. The Select Satellite menu will appear.
Future installation steps are depending from satellite where your dish is aimed.
4.2 Select Satellite
a) Your dish is aimed to Astra 1C, 1E, 1F or HOT BIRD satellite.
Press pq to select the ASTRA or HOT BIRD satellite and press OK. Follow the instructions.
When you have fixed your dish at correct direction choose NEXT and press OK. The Channel
Setup menu will appear.
Note: If OSD language “German” and satellite “Astra 19.2E” is chosen, the receiver will
automatically load German pre-installed channels at the beginning of the channel list.
If OSD language “Italian” and satellite “HOT BIRD 13E” is chosen, the receiver will
automatically load Italian pre-installed channels at the beginning of the channel list.
b) Your dish is aimed at another satellite
Select Other in Select satellite menu and press OK, more satellites will be listed. If you select one
out of the satellite list, the Configure Antenna menu will appear, please set the LNB Type, LNB
Low Freq, LNB High Freq, Band control, Polarisation control, DiSEqC Switch and Antenna mode.
4.3 Antenna mode
a) Fixed dish
Set Antenna mode to Fixed, select NEXT and press OK. The Adjust antenna screen appears,
select transponder receivable at your location and adjust the antenna position for maximum level
for the signal strength and quality. When adjustment is completed, choose NEXT and press OK.
The Channel Setup menu will appear.
b) Dish mounted on DiSEqC 1.2 motor
Set Antenna mode to DiSEqC 1.2, choose NEXT and press OK. The menu Adjust antenna will appear.
Select transponder receivable at your location (choose Transponder field and select transponder by
pressing tu). Then choose field Move Dish and adjust position of the dish by pressing the tu.
Once you adjusted the dish position choose Store position, set number of the position by pressing
tu. Then choose NEXT and press OK. The Channel Setup menu will appear.
c) Dish mounted on GOTO X motor
Set Antenna mode to GOTO X, choose NEXT and press OK. The menu Adjust antenna will
appear. Select transponder receivable at your location (choose Transponder field and select
transponder by pressing tu). Then choose field My Longitude and using numeric buttons
enter value of your longitude. Use tu to select hemisphere East or West. Then choose field My
Latitude and numeric buttons to enter value of your latitude. Use tu to select hemisphere Nord