3
OVERVIEW
These Structural Concepts cases are designed to
merchandise product at 3 separate temperature settings:
1. Refrigerated packaged PRODUCE/DELI products at
40 °F (4.5 °C) or less product temperatures.
2. Refrigerated packaged RAW MEAT products at 38 °F
(3.3 °C) or less product temperatures.
3. FROZEN packaged products at 0 °F (-18 °C) or less
product temperatures.
These cases should be installed and operated according to
the following parameters to insure proper performance.
See page 7 in operating manual for 3-way switch illustration.
TYPE I ENVIRONMENTAL CONDITIONS
This unit is designed for the display of products in ambient store
conditions where temperature and humidity are maintained
within a specific range.
Type I display refrigerators are intended for use in an area
where environmental conditions are controlled and maintained
so that the ambient temperature does not exceed 75 °F
(24 °C) and 55% maximum humidity.
WARNING
Hazardous moving parts. Do not operate unit with covers removed.
Fan blades may be exposed when deck panel is removed.
Disconnect power before removing deck panel.
WARNING
Risk of electric shock. Disconnect power before servicing unit.
CAUTION! More than one source of electrical supply is
employed with units that have separate circuits.
WARNING
Condensate Pan is Hot!
Disconnect and allow to cool before cleaning or removing from case.
WARNING
ELECTRICAL
HAZARD
WARNING
KEEP
HANDS
CLEAR
WARNING
HOT
SURFACE
OVERVIEW / TYPE / COMPLIANCE / WARNINGS / PRECAUTIONS / WIRING / PLUGS - PAGE 1 of 2
COMPLIANCE
This equipment MUST be installed in compliance with
all applicable NEC, federal, state and local
electrical and plumbing codes.
COMPLIANCE
Performance issues when in violation of applicable NEC,
federal, state and local electrical and plumbing codes are
not covered by warranty. See below.
WARNINGS
This sheet contains important warnings to prevent injury or
death. Please read carefully!
REFRIGERANT DISCLOSURE STATEMENT
This equipment is prohibited from use in California with any
refrigerants on the “List of Prohibited Substances” for that
specific end-use, in accordance with California Code of
Regulations, title 17, section 95374.
This disclosure statement has been reviewed and approved
by Structural Concepts and Structural Concepts attests,
under penalty of perjury, that these statements are true and
accurate.
ATTENTION
CONTRACTORS
WARNING: This product can expose you to chemicals, including
Urethane (Ethyl Carbamate), which are known to the state of
California to cause cancer and birth defects or other reproductive
harm. For more information go to P65Warnings.ca.gov.
To Next Page
Loading...
