What to do if Struers Laboratory Equipment is not draining water?
If water isn't draining, check for these possible causes: * A squeezed drain hose: Straighten the hose. * A clogged drain hose: Clean the hose. * A drain hose that doesn't slope downwards: Adjust the hose to an even slope.
What to do if Struers Laboratory Equipment cooling water stops?
If the cooling water stops, check if: 1. The water tap on the water supply is closed: Turn the water on. 2. The built-in water tap is closed: Turn the water on. 3. The built-in water tap is blocked: Clean water tap. 4. The filter at the water inlet is blocked: Clean the filter with compressed air only.
What to do if Struers Laboratory Equipment does not operate when the start switch is pressed?
If the machine doesn't start when you press the start switch: * Ensure that the main switch is on. Turn it on if it's off. * Check the fuse at the back of the machine and replace it if it's blown.
What to do if Struers Laboratory Equipment has water dripping underneath?
If you notice water dripping underneath the machine, it could be due to a leak in the water hose or a defect in the solenoid valve. To address this, turn off the main switch, disconnect the unit from the electrical power supply, turn off the water supply, and disconnect the unit from the water supply if needed. Contact Struers Service.
Why is there noise when Struers Laboratory Equipment starts, or why won't the turntable turn?
If you hear noise when the machine starts or the turntable won't turn, the belt might not be tight enough. The belt must be tightened. Contact Struers Service.
What to do if Struers Laboratory Equipment specimen holder plate vibrates?
If the specimen holder plate vibrates, it may be due to: * Loose specimen holder plate screws: Tighten the screws. * An unbalanced specimen holder plate: Replace the specimen holder plate.
How to fix Struers Laboratory Equipment if the specimen mover head does not rotate?
If the specimen mover head does not rotate, check if the switch is set to “off”. If rotation is required, set the switch to “on.
General| Type | Grinding and Polishing Machine |
|---|---|
| Speed Range | 50-600 rpm |
| Frequency | 50/60 Hz |
| Weight | 25 kg |
| Disc/Wheel Diameter | 200 mm |
| Voltage | 230 V |
To Next Page